Installing Gerber MAXX 2 Material Update:

This procedure will install the material update for MAXX 2.
This material update will allow require the use of Process Pro
foils for the MAXX 2 built-in calibration and test jobs.

Before performing the update, you must set the MAXX to accept a system update. 

1 On the MAXX control panel press Menu > Service > System Update. 
  The display shows:

     System ready for update
     Press CANCEL or MENU to exit:

  The red LED over the STOP key should blink to indicate
  system update mode.

2 Click Start > Programs > GSP OMEGA > GQMgr to open the GQ Mgr
  dialog box.

3 In the GQMgr dialog box click Help > About GQMgr... and verify 
  that you have Gerber Queue Manager Application 1,5,5,12 or 
  later installed.

***************************************************************
CAUTION: If you have multiple MAXX printers, it is important 
that you choose the correct MAXX to update in GQ Manager. 
Remember that each MAXX has a unique IP address on the network.
***************************************************************

4 Locate the MAXX that you have set for a system update. 
  Right click on the MAXX icon to access the drop-down menu.

5 Click Properties to open the Properties for Gerber MAXX
  dialog box.

6 Click Batch to open the GSP MAXX Batch File dialog box.

7 Browse to the MAXX material update folder and open it.

8 Click Mupdate.mxb. This installs the material update to the
  the MAXX hard disk. As the material update installs, 
  status messages automatically scroll through the Properties 
  for Gerber MAXX dialog box. Ignore any Failed messages that 
  scroll through the dialog box during the update process. 
  They are a normal messages during the update. Upon successful 
  installation of part one of the firmware the following 
  message displays:

     MAXX 2 MATERIALS UPDATED
     CYCLE POWER ON MAXX 2 
     TO COMPLETE MATERIALS UPDATE

9 Turn the MAXX off for at least 10 seconds. Turn the MAXX on.
  Wait for system to finish booting and display the message
  "Waiting for print job." You are now ready to use the MAXX.

====================================================================

Getting help

If you require assistance updating the firmware and you are in the USA, 
please contact the GSP Field Service department at: 

phone: 800-828-5406
fax: 860-648-8376
e-mail: gspservice@gspinc.com
www.gspinc.com

If you are outside the USA, please contact your distributor.

If you have OMEGA(TM) software, please have the following information ready as well:
* Microsoft(R) Windows(R) version number
* System serial number
* OMEGA, Windows, and hardware utilities diskettes